![]() READY and ERROR led will blinks (that’s mean firmware is flashing – wait for finish).Send firmware file to printer called Maintenance.Connect USB to machine and install drivers.Hold Power button for 2 seconds until Error led lits then release.If both leds lit you can release Power button. Press and hold Power button (Ready and Error LED lit) – you can release on the step 6.On windows 8 and above you have to disable driver singing policy: Manual install drivers and disable drivers signing policy on Windows 10, 8, 8.1įirst you have to switch printer to maintenance mode then install drivers and send the firmware file with FILEDG32 or PrintFile. ![]() There is mainteance drivers for win7 on a newer printers (both platform 圆4 and x86): I have found drivers for 圆4 but this printer works Maintenance Driver(1/3) which not works on 圆4.īrother Brother Maintenance USB Port drivers: Most recommended is Windows XP (you can do it on the virtual machine with redirected USB via virtualbox addons). To flash firmware in official way you have to do it on 32bit system. ![]() You can use FILEDG32.exe against PrintFile from there: I have described how to send RAW BIN files to printer: PJL – send commands to printer in RAW, BIN file You can send the firmware blf file directly to the printer with. It should work on other HL printers but you do it for your own risk.įirst read: PJL – send commands to printer in RAW, BIN file Firmware Enjoy and try create new one to other printers :) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |